Dell Force10 S2410-01-10GE-24P Command Reference Manual page 293

Example Figure 18-108. show interfaces description Command Example
S50 #conf
S50 (Config)#interface 1/0/1
S50 (Interface 1/0/1)#description "1/0/1 is access port"
S50 (Interface 1/0/1)#exit
S50 (Config)#interface 1/0/30
S50 (Interface 1/0/30)#description 'management port in vlan 30'
S50 (Interface 1/0/30)#exit
S50 (Config)#exit
S50 #show interfaces description 1/0/1
Interface.......1/0/1
IfIndex.........1
Description.....1/0/1 is access port
MAC Address.....00:01:E8:D5:BA:C0
Bit Offset Val..1
S50 #show interfaces description 1/0/30
Interface.......1/0/30
IfIndex.........30
Description.....management port in vlan 30
MAC Address.....00:01:E8:D5:BA:C0
Bit Offset Val..30
S50 #
Related
interface vlan
Commands
show interfaces
show running-config
dot1p-priority
This command configures the priority for untagged frames.
dot1p-priority 0–7
Syntax
The 0–7 field is an integer that sets the priority value for untagged frames received.
Mode Interface Port Channel Config
Command
Version 2.5.1
History
Related
channel-member
Commands
interface
port-channel
show interfaces
port-channel
Creates a VLAN, assigns it an ID and then enters the Interface VLAN mode
Displays information, including the description, about a selected interface.
Display/capture the current setting of different protocol packages supported on the
switch.
Introduced in the new Interface Port Channel Config mode.
Add a port or range of ports to the selected LAG. LAG ports must be physical ports,
not other LAGs.
Creates the port channel (LAG) or, if the port channel is already created, invokes the
Interface Port Channel Config mode.
Displays an overview of all port channels (LAGs) on the switch or details on the
selected LAG.
LAG/Port Channel Commands | 293