Dell Force10 S2410-01-10GE-24P Command Reference Manual page 92

Defaults
Mode
Command
History
Usage
Information
| System Configuration Commands
92
port-channel
Enter the keyword
commas or grouped in a range, as above: For example:
,...
range,range
port-channel 3-5
and 5 to three port channels.)
vlan
Enter the keyword
, range ,
... by commas or grouped in a range in this form:
range
vlan 10,33-50
As above, spaces are not allowed around commas or hyphens, and you can enter up to
six comma-separated ranges.
This command has no default behavior or values.
Global Config
Version 2.3
The interface range command invokes the Interface Range mode, more specifically, one of three
versions of it—Ethernet Range, Port Channel Range, or VLAN Range. Here, you can execute
commands that modify the selected interface or set of interfaces. These commands have the same
effect as they do when they are used within the Interface VLAN or Interface Config modes (see
interface vlan on page 129
interface on page 91 and
Important things to remember:
• You can only modify, not create, interfaces (ethernet ports, LAGs, and VLANs) using the
interface range command.
• A range command can include only one type of interface—VLAN, physical, or LAG. You can use
the show running-config command to note VLAN and LAG (port channel) interfaces that are
available to be used with the interface range command.
• Bulk configuration is created if at least one interface is valid, automatically excluding non-existing
interfaces from the bulk configuration and generating a warning message.
• When creating an interface range, interfaces appear in the order they are entered; they are not
sorted. The command verifies that interfaces are present (physical) or configured (logical).
• The resulting interface range prompt includes interface types with slot/port information for valid
interfaces, for example:
allows for a maximum of 32 characters. If the bulk configuration exceeds 32 characters, it is
represented by an ellipsis ( ... ).
• If the interface range prompt has multiple port ranges, the smaller port range is excluded from the
prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest start port and the
biggest end port.
port-channel
and one or more port channel IDs separated by
(In this example, you previously assigned IDs 3, 4,
vlan
and one or more VLAN numbers, from 1 to 3965, separated
Introduced
).
(conf-if-range-et-1/0/10-1/0/11)# . The prompt