Slot and Card Commands
set slot disable
Command
History
set slot power
Command
History
show slot
Syntax
Mode
Example
Report Fields
|
Stacking Commands
226
This section provides detailed explanations of the slot and card commands:
•
set slot disable on page 226
•
set slot power on page 226
•
show slot on page 226
•
show supported cardtype on page 227
•
slot on page 229
Version 2.3
Replaced by the
Version 2.3
Replaced by the
This command displays information about all the slots in the system, or, when the unit/slot argument is
included, this command displays information for the requested slot in the specified stack member. If
that slot holds a card or module, information about the contents of the slot is also displayed.
show slot [unit/slot]
User Exec; Privileged Exec
Figure 12-82. Using the show slot command
Force10 #show slot
Admin
Slot
Status
State
----- ------ ------- ------- -------------------------------- --------- -----
1/0
Full
Enable
Enable
2/0
Empty
Enable
Disable SA-01-10GE-2P
3/0
Empty
Enable
Disable SA-01-10GE-2P
Figure 12-82
shows three S50 switches in a stack. "Slot" 1/0 indicates with "Full" in the Status column
that the unit contains a 10Gb module.
Slot—This field displays the slot identifier in a
Slot Status—This field indicates whether the slot is empty, full, or has encountered an error.
slot
command.
slot
command.
Power
Configured Card
State
Model ID
SA-01-10GE-2P
format.
unit/slot
Hot
Power
Pluggable Down
No
No
No
No
No
No