Ip Access-Group All; Show Ip Access-Lists - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Mode
Command
History
Related
Commands

ip access-group all

Syntax
Default
Mode

show ip access-lists

Syntax
Parameters
Mode
Example
| ACL Commands
382
Interface Config (including Interface Loopback Config) and Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3
interface range
access-list
ip address (routed)
ip access-group (port channel)
show ip access-lists
This command attaches a specified IP access control list to all interfaces.
ip access-group all
ACLnumber
none
Global Config
This command displays an IP Access Control List (ACL) and all of the rules that are defined for the
ACL. The is the number used to identify the ACL.
ACLnumber
show ip access-lists [
ACLnumber
ACLnumber
Privileged Exec and User Exec
Figure 21-124. Command Example: show ip access-lists
Force10-S50 #show ip access-lists
Current number of ACLs: 3 Maximum number of ACLs: 100
ACL ID Rules Direction
------ ----- ----------
1 38 inbound
2 1
3 1
Interface Range mode added
Defines an interface range and accesses the Interface Range mode.
Creates an IP access control list.
configures an IP address on a routed interface.
Attaches an ACL to the selected port channel.
Displays an IP Access Control List (ACL) and all of the rules that are defined
for the ACL.
] in
[ 1 – 4294967295
]
Enter the ACL ID in the range of 1 to 199.
Interface(s)
-------------------------
1/0/48