Dell Force10 S2410-01-10GE-24P Command Reference Manual page 111

quit
This command duplicates the functionality of the logout command, closing the current Telnet
connection, or resetting the current serial connection.
quit
Syntax
Mode
Privileged Exec
Related
logout
Commands
ping
This command checks if another computer is on the network and listens for connections. To use this
command, configure the switch for network (in-band) connection. The source and target devices must
have the ping utility enabled and running on top of TCP/IP. The switch can be pinged from any IP
workstation with which the switch is connected through the default VLAN (VLAN 1), as long as there
is a physical path between the switch and the workstation. The terminal interface sends three pings to
the target station.
ping ipaddr
Syntax
Mode
Privileged Exec and User Exec
reload
This command resets the switch without powering it off. Reset means that all network connections are
terminated and the boot code executes. The switch uses the stored configuration to initialize the switch.
You are prompted to confirm that the reset should proceed. A successful reset is indicated by the LEDs
on the switch.
reload [ unit ]
Syntax
For unit , enter a switch ID in the range of 1 to 8.
Mode
Privileged Exec
For a sample of the output from the reload command, see the section "Upgrading the Software
Usage
Information
Image" in the Getting Started chapter of the SFTOS Configuration Guide.
Command
Version 2.5.1
History
Related
copy
Commands
Note:
Save configuration changes before logging out.
lose the current Telnet connection, or reset the current serial connection
C
Modified:
Downloads and uploads various file types, and copies software between stack
members.
[ ] parameter added
unit
System Configuration Commands | 111
.