Show Dvlan-Tunnel; Show Dvlan-Tunnel L2Pdu-Forwarding - Dell Force10 S2410-01-10GE-24P Command Reference Manual

show dvlan-tunnel

This command displays whether an interface is enabled for Double VLAN Tunneling, along with the
system-configured etherType and detailed information about Double VLAN Tunneling for the
specified interface, or a list of interfaces and their tunneling status. This command performs the same
function as show dot1q-tunnel.
show dvlan-tunnel [interface {unit/slot/port | all}]
Syntax
Parameters
interface
all
Mode
Privileged Exec and User Exec
Command
Version 2.5.2
History
Version 2.5.1
Example Figure 7-52. Example of Output from the show dvlan-tunnel interface Command
Force10 #show dvlan-tunnel interface 1/0/1
Interface Mode
--------- ------- --------------
1/0/1
Force10 # show dvlan-tunnel interface all
Interface Mode
--------- ------- --------------
1/0/1
1/0/2
1/0/3
1/0/4
1/0/5
1/0/6
1/0/7
!-----------output truncated-------------!
Related
dvlan-tunnel ethertype
Commands
mode dot1q-tunnel
mode dvlan-tunnel

show dvlan-tunnel l2pdu-forwarding

This command displays the current l2pdu tunneling configuration present on the switch.
show dvlan-tunnel l2pdu-forwarding
Syntax
Mode
Privileged Exec
{ unit/slot/port |
}]
Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
EtherType
Disable 802.1Q
EtherType
Disable 802.1Q
Disable 802.1Q
Disable 802.1Q
Disable 802.1Q
Disable 802.1Q
Disable 802.1Q
Disable 802.1Q
Configures the etherType for all vlan-stack (Double VLAN tagging) interfaces on
the system.
Enable Double VLAN Tunneling on the specified interface.
same as above
interface
(OPTIONAL) Enter the
unit/slot/port
address in the form of
keyword followed by either a specific
all
or enter the word .
VLAN Commands | 155