Ip Ospf Hello-Interval - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Mode Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
Version 2.3
History
Related
interface range
Commands
interface vlan
ip ospf
hello-interval
show ip ospf
neighbor
show ip ospf
interface

ip ospf hello-interval

This command sets the OSPF hello interval for the specified interface.
ip ospf hello-interval seconds
Syntax
The value for seconds is a valid positive integer, which represents the length of time in seconds. The
value for the length of time must be the same for all routers attached to a network.
Range: 1 to 65535
The no ip ospf hello-interval command sets the OSPF hello interval for the specified interface to
the default.
Default 10
Mode
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
Version 2.3
History
Related interface range
Commands
interface vlan
ip ospf
dead-interval
show ip ospf
interface
Added Interface Range and Interface VLAN modes.
Defines an interface range and accesses the Interface Range mode
Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
Sets the OSPF hello interval for the specified interface
Displays the OSPF neighbor table list
Displays the information for the IFO object or virtual interface tables
Added Interface Range and Interface VLAN modes.
Defines an interface range and accesses the Interface Range mode
Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
Sets the OSPF dead interval for the specified interface
Displays the information for the IFO object or virtual interface tables
OSPF Commands | 435