Dell Force10 S2410-01-10GE-24P Command Reference Manual page 402

Example 2
Example 3
Report Fields
| Routing Commands
402
Figure 22-130. show ip interface output Command Example
(Force10) #show ip interface 1/0/1
Routing Mode................................... Disable
Administrative Mode............................ Disable
Forward Net Directed Broadcasts................ Disable
Proxy ARP...................................... Enable
Active State................................... Inactive
Link Speed Data Rate........................... Inactive
MAC Address.................................... 00:01:E8:D5:A2:1A
Encapsulation Type............................. Ethernet
IP MTU......................................... 1500
Note:
Example 2
routing is disabled.
Example 3 (Figure 22-131 on page
Figure 22-131. show ip interface output with Routing Enabled
(Force10) #show ip interface 1/0/1
Primary IP Address............................. 1.1.1.10/
255.255.255.0
Routing Mode................................... Enable
Administrative Mode............................ Enable
Forward Net Directed Broadcasts................ Disable
Proxy ARP...................................... Enable
Local Proxy ARP................................ Disable
Active State................................... Inactive
Link Speed Data Rate........................... Inactive
MAC Address.................................... 00:01:E8:D5:A0:DB
Encapsulation Type............................. Ethernet
IP MTU......................................... 1500
Primary IP Address—Displays the primary IP address and subnet masks for the interface.
This value appears only if you configure it.
Secondary IP Address—Displays one or more secondary IP addresses and subnet masks
for the interface. This value appears only if you configure it.
Routing Mode—Is the administrative mode of router interface participation. The possible
values are Enable or Disable. This value is configured.
Administrative Mode—Is the administrative mode of the specified interface. The possible
values of this field are Enable or Disable. This value is configured.
Routing Configuration—Displays whether Routing Configuration is enabled or disabled
on the system.
Interface Configuration—Status Displays whether the Interface Configuration is enabled
or disabled on the system.
Forward Net Directed Broadcasts—Displays whether forwarding of network-directed
broadcasts is enabled or disabled. This value was configured into the unit.
Proxy ARP—Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARP—Displays whether Local Proxy ARP is enabled or disabled on the
interface.
(Figure 22-130 on page 402) shows the output of the command when
402) shows the output when routing is enabled.