Vlan Commands; Virtual Lan (Vlan) Commands - Dell Force10 S2410-01-10GE-24P Command Reference Manual

VLAN Commands

Use the commands in this chapter to configure virtual local area networks (VLANs) that conform to
IEEE 802.1Q. The three major sections in this chapter are:
•
•
•

Virtual LAN (VLAN) Commands

In SFTOS 2.3.1, the aoCEst OEubg ou
VLAN configuration. Execute the command from the Global Config mode.
Executing the aoCEst OEubg ou
already exist; otherwise, the command selects an existing VLAN. Then, in either case, the command
invokes the Interface VLAN mode, in which you have access to VLAN configuration commands for
the specified VLAN.
Table 7-19. Commands in the Interface VLAN Mode
.EnOsadCaeo
encapsulation
(VLAN)
exit
help
igmp
ip
IP Subnet-based
VLANs
MAC-based VLANs
Virtual LAN (VLAN) Commands
Protected-Port (PVLAN) Commands on page 147
VLAN-Stacking Commands on page 150
Note:
You can also configure VLANs with bulk configuration commands. See
range on page 91.
command creates a new VLAN if the identified VLAN ID does not
Command/Command Family
Commands
Add a description to the VLAN.
Configure interface link layer encapsulation
type.
Leave the mode.
Display help for various special keys.
Configure IGMP Snooping parameters for
the VLAN.
Configure IP parameters.
Associate the VLAN with the IP address and
subnet mask for a desired partitioning of the
network.
Define MAC addresses that belong to the
same VLAN.
command (see interface vlan on page
Description
129) is the starting point for
interface
Location of
Command Syntax Description
This chapter
This chapter
IGMP Snooping Commands on page 273
IGMP Commands on page 471
Multicast chapter)
These commands are not part of the
Layer 2 Package used for the S2410. See
Virtual LAN Routing Commands on
page 413.
Not supported in this release
Not supported in this release
VLAN Commands | 125
7
(IP