Ip Route Default; Ip Route Distance - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Mode

ip route default

Syntax
Default
Mode

ip route distance

Syntax
Default
Mode
ip routing
Syntax
Mode
| Routing Commands
400
Global Config
This command configures the default route. The value for nextHopRtr is a valid IP address of the next
hop router. The preference is an integer value from 1 to 255.
The no version of this command deletes all configured default routes. If the optional nextHopRtr
parameter is designated, the specific next hop is deleted from the configured default route and if the
optional preference value is designated, the preference of the configured default route is reset to its
default.
ip route default nextHopRtr [preference]
no ip route default [{nextHopRtr | preference}]
preference - 1
Global Config
This command sets the default distance for static routes. Lower route preference values are preferred
when determining the best route. The "ip route" and "ip route default" commands allow you to
optionally set the distance of an individual static route. The default distance is used when no distance is
specified in these commands. Changing the default distance does not update the distance of existing
static routes, even if they were assigned the original default distance. The new default distance will
only be applied to static routes created after invoking the "ip route distance" command.
The no version of this command sets the default static route preference value in the router. Lower
route preference values are preferred when determining the best route.
ip route distance 1-255
no ip route distance
1
Global Config
This command enables the IP Router Admin Mode for the switch.
[no] ip routing
The no version of this command disables the IP Router Admin Mode for the switch.
Global Config