Show Snmpcommunity; Show Snmptrap - Dell Force10 S2410-01-10GE-24P Command Reference Manual

show snmpcommunity

Syntax
Mode

show snmptrap

Syntax
Mode
| System Management Commands
78
This command displays SNMP community information. Six communities are supported. You can add,
change, or delete communities. The switch does not have to be reset for changes to take effect.
The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP
specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external
SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community
parameters).
show snmpcommunity
Privileged Exec
Table 5-14. Fields of show snmpcommunity Command Output
Field Description
SNMP Community The community string to which this entry grants access. A valid entry is a case-sensitive
Name alphanumeric string of up to 16 characters. Each row of this table must contain a unique
community name.
Client IP Address An IP address (or portion thereof) from which this device will accept SNMP packets with
the associated community. The requesting entity's IP address is ANDed with the Subnet
Mask before being compared to the IP Address. Note: that if the Subnet Mask is set to
0.0.0.0, an IP Address of 0.0.0.0 matches all IP addresses. The default value is 0.0.0.0.
Client IP Mask A mask to be ANDed with the requesting entity's IP address before comparison with IP
Address. If the result matches with IP Address then the address is an authenticated IP
address. For example, if the IP Address = 9.47.128.0 and the corresponding Subnet Mask
= 255.255.255.0 a range of incoming IP addresses would match, i.e. the incoming IP
Address could equal 9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0.
Access Mode The access level for this community string
Status The status of this community access entry
This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP
Network Manager. These messages alert the manager to events occurring within the switch or on the
network. Six trap receivers are simultaneously supported.
show snmptrap
Privileged Exec
Table 5-15. Fields of show snmptrap Command Report
Field Description
SNMP Trap Name The community string of the SNMP trap packet sent to the trap manager. This may be up
to 16 alphanumeric characters. This string is case sensitive.
IP Address The IP address to receive SNMP traps from this device. Enter four numbers between 0
and 255 separated by periods.
Status Indicates the receiver's status (enabled or disabled)