Snmptrap Ipaddr; Snmptrap Mode; Snmp Trap Link-Status (Interface) - Dell Force10 S2410-01-10GE-24P Command Reference Manual

snmptrap ipaddr

Syntax
Mode

snmptrap mode

Syntax
Mode

snmp trap link-status (interface)

Syntax
Mode
Command
History
Related
Commands
| System Management Commands
84
This command assigns an IP address to a specified community name. The maximum name length is 16
case-sensitive alphanumeric characters.
Note:
IP addresses in the SNMP trap receiver table must be unique. If you make multiple
entries using the same IP address, the first entry is retained and processed. All duplicate
entries are ignored.
snmptrap ipaddr name ipaddrold ipaddrnew
Global Config
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive
traps). Disabled trap receivers are inactive (not able to receive traps).
[no] snmptrap mode name ipaddr
The no version of this command deactivates an SNMP trap. Disabled trap receivers are inactive (not
able to receive traps).
Global Config
This command enables link status traps by interface.
[no] snmp trap link-status
The oe version of this command disables link status traps by interface.
Note:
This command is valid only when the Link Up/Down Flag is enabled. See
no,d6nEsbEsuEo rgEuCs dnugaoR,e.E
Interface
Config (including Interface Loopback Config); Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.5.1 Added Interface Loopback Config mode.
Version 2.3 Added Interface Range mode.
interface range Defines an interface range and accesses the Interface Range mode
interface Identifies an interface and enters the Interface Config mode.
snmp trap link-status enables link status traps for the selected port channel
(port channel)
command.