Igmp Interfacemode Enable All; Igmp Maxresponse - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Command
History
Related
Commands

igmp interfacemode enable all

Syntax
Default
Mode
Command
History
Related
Commands

igmp maxresponse

Syntax
Default
| IGMP Snooping Commands
276
Version 2.3
Modified: Revised from
Range mode.
Version 2.5.1 Added Interface Port Channel Config mode
igmp enable (interface) Enables IGMP Snooping on a selected interface.
interface range Defines an interface range and accesses the Interface Range mode
interface Identifies an interface and enters the Interface Config mode.
show igmpsnooping Displays IGMP Snooping status information.
This command enables IGMP Snooping on all interfaces. If an interface that has IGMP Snooping
enabled is enabled for routing or is enlisted as a member of a port channel (LAG), IGMP Snooping
functionality will be disabled on that interface. IGMP Snooping functionality will be subsequently
re-enabled if routing is disabled or port-channel (LAG) membership is removed from an interface that
has IGMP Snooping enabled.
[no] igmp interfacemode enable all
The no version of this command disables IGMP Snooping on all interfaces.
disabled
Global Config
Version 2.3 Changed from
igmp enable (interface)
show igmpsnooping
This command sets the IGMP maximum response time on a selected interface, including VLAN and
LAG interfaces. The maximum response time is the amount of time in seconds that a switch will wait
after sending a query on an interface because it did not receive a report for a particular group in that
interface.
igmp maxresponse 1-3599
The variable must be less than the IGMP query interval time value. The range is 1 to 3599 seconds.
The no igmp maxresponse com
the default value.
10 seconds
set igmp groupmembership-interval.
set igmp interfacemode all
This command enables IGMP Snooping on a selected interface.
Displays IGMP Snooping status.
mand
sets the IGMP maximum response time on the interface to
Added Interface