Clear Port-Channel - Dell Force10 S2410-01-10GE-24P Command Reference Manual

classofservice dot1p-mapping

clear port-channel

Syntax
Mode
Related
Commands
cos-queue max-bandwidth
Syntax
Modes
no cos-queue max-bandwidth
Syntax
Mode
cos-queue min-bandwidth
| LAG/Port Channel Commands
290
See classofservice dot1p-mapping on page 328
This command removes all currently configured port-channels (LAGs).
clear port-channel
Privileged Exec
cos-queue max-bandwidth
interface port-channel
show interfaces port-channel
This command specifies the maximum transmission bandwidth limit for each interface queue. Also
known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so that the
transmitted traffic rate is bounded. The total number of queues supported per interface is platform
specific.
Oen6HWEWEu, G6r o.Aa.Ciu <bw-0> <bw-1> ... <bw-n>
Global Config and Interface Config
This command restores the default for each queue's maximum bandwidth value.
no cos-queue max-bandwidth
Global Config and Interface Config
See cos-queue min-bandwidth on page 330
in the QoS chapter.
Deletes the selected port from the specified logical interface.
Creates the port channel (LAG) or, if the port channel is already created,
invokes the Interface Port Channel Config mode.
Displays an overview of all port channels (LAGs) on the switch or details on
the selected LAG.
in the QoS chapter.