Dell Force10 S2410-01-10GE-24P Command Reference Manual page 98

no monitor session 1
Syntax
Default
Mode
rate-interval
Syntax
Default
Mode
Command
History
show forwardingdb agetime
Syntax
Mode
Example
Command
History
| System Configuration Commands
98
This command removes all the source ports and a destination port of the mirroring session and restore
the default value for mirroring session mode.
The 1 or session-id parameter is an integer value used to identify the session. In the current version of
the software, the session-id parameter is always 1.
This is a stand-alone "no" command. This command does not have a "normal" form. This command
can be issued without regard for the session status (enabled or disabled).
no monitor session 1
enabled
Global Config
This command sets the traffic monitoring rate interval in seconds.
rate-interval 15-300
299 seconds
Interface Config; Interface Port Channel Config; Interface Range Ethernet; Interface Range Port
Channel
Version 2.5.1 Introduced
This command displays the timeout for address aging. In an SVL system, the [fdbid | all] parameter is
not used and will be ignored if entered.
show forwardingdb agetime
Privileged Exec
Figure 6-31. Example of show forwardingdb agetime Command Output
Force10 #show forwardingdb agetime
Address Aging Timeout:300
Force10#
Version 2.3 Modified: Removed parameters and statements relating to IVL.