Dell Force10 S2410-01-10GE-24P Command Reference Manual page 65

show running-config
This command is used to display/capture the current setting of different protocol packages supported
on the switch. This command displays/captures only commands with settings/configurations with
values that differ from the default value. The output is displayed in script format, which can be used to
configure another switch with the same configuration.
show running-config [all] [ scriptname ]
Syntax
The option all adds the display/capture of default values. When a script name is provided for the
scriptname variable, the output is redirected to a configuration script. If the variable includes a file
name extension of ".scr", the output will be redirected to a script file.
Mode
Privileged Exec
port-channel staticcapability
If
Example Figure 5-20. Using the show running-config command
(S50-5) #show running-config all
!Current Configuration:
!
configure
!System Description "Force10 S50"
!System Description 2.3.1.5
hostname "S50-5"
no dvlan-tunnel l2pdu-forwarding enable
no ip ssh server enable
sshcon maxsessions 5
sshcon timeout 5
no ip http javamode enable
no ip http secure-server enable
ip http secure-server enable
ip http secure-protocol TLS1 SSL3
ip http secure-port 443
no ip http server enable
ip http server enable
sntp unicast client poll-interval 6
sntp broadcast client poll-interval 6
logging buffered
no dvlan-tunnel l2pdu-forwarding mac-address
no gmrp adminmode enable
no gvrp adminmode enable
sntp unicast client poll-retry 1
sntp unicast client poll-timeout 5
sntp client port 123
stack
member 1 1
exit
logging buffered wrap
no logging console
logging facility local7
Note:
This sample of the output is just a small part of the many thousands of lines that can be
generated by this command.
is enabled,
the device has static capability enabled.
System Management Commands | 65