Show Arp; Clear Arp-Cache - Dell Force10 S2410-01-10GE-24P Command Reference Manual

clear arp-cache

Syntax
Mode
ip proxy-arp
Syntax
Default
Mode
Command
History

show arp

Syntax
Mode
| Routing Commands
394
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If the
gateway parameter is specified, the dynamic entries of type gateway are purged as well.
clear arp-cache [gateway]
Privileged Exec
This command enables proxy ARP on a router interface.
Without proxy ARP, a device only responds to an ARP request if the target IP address is an address
configured on the interface where the ARP request arrived. With proxy ARP, the device may also
respond if the target IP address is reachable. The device only responds if all next hops in its route to the
destination are through interfaces other than the interface that received the ARP request.
[no] ip proxy-arp
The no version of this command disables proxy ARP on a router interface.
enabled
Interface Config or Interface VLAN
Version 2.3
Modified: Added Interface VLAN as a mode.
This command is only available for the Layer 3 software package. It displays the Address Resolution
Protocol (ARP) cache, all the ARP entries learned through the routing engine.
The displayed results are not the total ARP entries. To view the total ARP entries, combine the show
arp results with the show arp switch results (That command is available in the base Layer 2
software package.)
show arp
Privileged Exec