Show Stack-Port Diag - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Example 2

show stack-port diag

Syntax
Mode
| Stacking Commands
220
Configured Stack Mode—Stack or Ethernet
Stack Mode—Stack or Ethernet
Link Status—Status of the link
Link Speed—Speed (Gb/s) of the stack port link
The S50V has two expansion slots for up to four stacking ports, so this report is set up to display all
four ports, as shown in Figure
module is installed, but it is not linked). The ports are numbered left to right as you face them on the
back of the chassis.
Figure 12-77. Example of Output from the show stack-port counters Command on an
S50V
Force10-S50V#show stack-port counters
Unit Interface
---- ---------------- ------ ---------- ---------- ------ ---------- ----------
1 0/49
1 0/50
1 0/51
1 0/52
When the counters argument is used, the report contains the following fields:
Unit—Unit
Interface—Stack port number (A or B)
Tx Data Rate—Transmit data rate in megabits per second on the stacking port
Tx Error Rate—Platform-specific number of transmit errors per second
Tx Total Errors—Platform-specific number of total transmit errors since power-up
Rx Data Rate—Receive data rate in megabits per second on the stacking port
Rx Error Rate—Platform-specific number of receive errors per second
Rx Total Errors—Platform-specific number of total receive errors since power-up
This command shows stacking diagnostics for each port and is only intended for Field Application
Engineers (FAEs) and developers. An FAE will advise on the necessity to run this command and
capture this information.
show stack-port diag
Privileged Exec
Unit—Unit
12-77, whether or not all are installed (in this case, only a 10G XFP
------------TX-------------- ------------RX--------------
Data Error
Rate Rate Total
(Mb/s) (Errors/s) Errors
0 0 0
0 0 0
0 0 0
0 0 0
Data Error
Rate Rate Total
(Mb/s) (Errors/s) Errors
0 0 0
0 0 0
0 0 0
0 0 0