Broadcast Storm Control Commands; Show Storm-Control - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Broadcast Storm Control Commands

This section contains the following commands:
•
•
•

show storm-control

This command displays switch configuration information.
show storm-control [unit/slot/port | all]
Syntax
Mode
Privileged Exec
Broadcast Storm Recovery Mode—May be enabled or disabled. The factory default is disabled.
Defaults
802.3x Flow Control Mode—May be enabled or disabled. The factory default is disabled.
Example Figure 21-126. Command Example: show storm-control
Force10-S50 #show storm-control
802.3x Flow Control Mode....................... Disable
Force10-S50 #show storm-control 1/0/1
------ ------- ------- ------- ------- ------- -------
1/0/1
Force10-S50 #show storm-control all ?
<cr>
Force10-S50 #show storm-control all
------ ------- ------- ------- ------- ------- -------
1/0/1
1/0/2
1/0/3
1/0/4
1/0/5
1/0/6
1/0/7
1/0/8
1/0/9
!-----------output truncated---------------!
Related
storm-control broadcast
Commands
show interface ethernet
show storm-control
storm-control broadcast on page 390
storm-control flowcontrol on page 390
Bcast Bcast
Intf Mode Level
Disable 5
Bcast Bcast
Intf Mode Level
Disable 5
Disable 5
Disable 5
Disable 5
Disable 5
Disable 5
Disable 5
Disable 5
Disable 5
Mcast Mcast Ucast
Mode Level Mode
Disable 5 Disable
Press enter to execute the command.
Mcast Mcast Ucast
Mode Level Mode
Disable 5 Disable
Disable 5 Disable
Disable 5 Disable
Disable 5 Disable
Disable 5 Disable
Disable 5 Disable
Disable 5 Disable
Disable 5 Disable
Disable 5 Disable
Configure storm control.
The report generated by the
contains broadcast storm statistics.
Ucast
Level
5
Ucast
Level
5
5
5
5
5
5
5
5
5
show interface ethernet
ACL Commands | 389
command