Dell Force10 S2410-01-10GE-24P Command Reference Manual page 352

police-simple
Syntax
Defaults
Mode
Restrictions
Policy Type
Incompatibilities
Related
Commands
| Quality of Service (QoS) Commands
352
This command establishes the traffic policing style for the specified class.
police-simple {
1-4294967295 1-128
set-dscp-transmit | set-cos-transmit
0-63
transmit} [violate-action drop]}
The simple form of the command uses a single data rate and burst size, resulting in two outcomes:
conform and nonconform.
The conforming data rate is specified in kilobits-per-second (Kbps) and is an integer from 1 to
4294967295. The conforming burst size is specified in kilobytes (KB) and is an integer from 1 to 128.
For each conforming outcome (conform-action), the possible actions are drop, set-cos-transmit,
set-sec-cos-transmit, set-dscp-transmit, set-prec-transmit,
For set-dscp-transmit, a
dscpval
or symbolically through one of the following keywords: af11, af12, af13, af21, af22, af23, af31,
af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef, as described in
ip-dscp on page 350.
For set-prec-transmit, an IP Precedence value is required and is specified as an integer from 0-7.
In this version of SFTOS, the violate-action is limited to drop.
In this simple form of the police command, the conform action defaults to transmit and the violate
action defaults to drop. These actions can be set with this command once the style has been
configured.
Policy Class (The prompt is "(Config-policy-classmap)#")
Only one style of the police command (police-simple) is allowed for a given class instance in a
particular policy.
In
Mark IP DSCP, Mark IP Precedence
class-map match-all Defines a new DiffServ class of type match-all.
class Creates an instance of a class definition within the specified policy for the purpose
of defining treatment of the traffic class through subsequent policy attribute
statements.
traffic-shape Specifies the maximum transmission bandwidth limit for the interface as a whole.
Used for egress rate shaping only.
conform-action {drop | set-prec-transmit
| set-secondary-cos-transmit
0-7
value is required and is specified as either an integer from 0 to 63,
|
0-7
0-7 |
transmit.
or
mark