Encapsulation (Vlan) - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Usage
Information
Example
Related
Commands

encapsulation (VLAN)

Syntax
Default
Mode
Command
History
Related
Commands
| VLAN Commands
128
The following example shows the use of both single quotes and double quotes in entering a description
for a port. The example also shows the resulting descriptions presented in show interfaces
description commands.
Figure 7-40. show interfaces description Command Example
S50 #conf
S50 (Config)#interface 1/0/1
S50 (Interface 1/0/1)#description "1/0/1 is access port"
S50 (Interface 1/0/1)#exit
S50 (Config)#interface 1/0/30
S50 (Interface 1/0/30)#description 'management port in vlan 30'
S50 (Interface 1/0/30)#exit
S50 (Config)#exit
S50 #show interfaces description 1/0/1
Interface.......1/0/1
IfIndex.........1
Description.....1/0/1 is access port
MAC Address.....00:01:E8:D5:BA:C0
Bit Offset Val..1
S50 #show interfaces description 1/0/30
Interface.......1/0/30
IfIndex.........30
Description.....management port in vlan 30
MAC Address.....00:01:E8:D5:BA:C0
Bit Offset Val..30
S50 #
description (port channel)
interface vlan
show interfaces
show running-config
This command configures the link layer encapsulation type for the packet within the VLAN.
Acceptable encapsulation types are Ethernet and SNAP.
encapsulation {ethernet | snap}
ethernet
Interface VLAN
Restrictions—Routed frames are always Ethernet-encapsulated when a frame is routed to a VLAN.
Version 2.3 Introduced
interface vlan Creates a VLAN, assigns it an ID and then enters the Interface VLAN mode
encapsulation Configures the link layer encapsulation type for the packet within the specific
(interface) interface.
Add a description for the selected port channel.
Creates a VLAN, assigns it an ID and then enters the Interface VLAN mode
Displays information, including the description, about a selected interface.
Display/capture the current setting of different protocol packages supported on
the switch.