Dell Force10 S2410-01-10GE-24P Command Reference Manual page 70

Related
Commands
vlan participation (management VLAN only)
Syntax
Mode
Default
Command
History
Related
Commands
| System Management Commands
70
Table 5-12. Fields in Output of show version Command (continued)
Headings
Software Version
Additional Packages
10/100 Ethernet/802.3 interface(s)
Gig Ethernet/802.3 interface(s)
10Gig Ethernet/802.3 interface(s)
Virtual Ethernet/802.3 interface(s)
System Name
System Location
System Contact
System Object ID
System Up Time
show hardware
show sysinfo
show tech-support
This command assigns the management VLAN of the switch.
[no] vlan participation vlan_id
The value for vlan_id is the VLAN that you want to use for the management interface (By default,
VLAN 1 is used.)
Interface ManagementEthernet. Uses the (Config-if-ma)# prompt, accessed by
managementethernet.
VLAN 1 (default management VLAN; all enabled ports are on VLAN 1 by default, so all ports are
capable, by default, of being management ports.)
Version 2.3
Introduced: Replaces the command
management route default
interface managementethernet
Explanation
The release.version.revision number of the code currently
running on the switch
This displays the additional packages that are incorporated into
this system, such as Dell Force10 Multicast.
Copper ports running at 10/100 speed reporting link UP
Copper/fiber ports running at 1Gb speed reporting link UP
10Gb optional module
Layer 3 VLAN interfaces
Inventory information for the switch
Switch information, including list of supported MIBs
show
Displays the output of many
network mgmt_vlan on page 131
Sets the IP gateway of the switch.
Invokes the Interface ManagementEthernet mode, the
(Config-if-ma)# prompt.
commands, including this one.
interface
.