Uploading From The Switch Through Xmodem - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Command Syntax
show interface
managementethernet
interface
managementethernet
ip address ipaddr
netmask
management route
default gateway

Uploading from the Switch through XMODEM

Command Syntax
copy {nvram:startup-config |
nvram:errorlog | nvram:log |
nvram:traplog} xmodem://filepath/
filename
See copy on page 106
Started chapter of the SFTOS Configuration
Guide.
| Quick Start
20
To configure the management IP address, use the following commands:
Command Mode
Privileged Exec
Global Config
Interface Config
Global Config
For details on command syntax for the commands listed above, see
Information Commands on page
To copy to a PC from the switch console port with XMODEM, use the following commands.
Command Mode
Privileged Exec
and the Getting
Purpose
Displays the Network Configurations
IP Address: IP Address of the interface. Default IP is 0.0.0.0
Subnet Mask: IP Subnet Mask for the interface. Default is 0.0.0.0
Default Gateway: The default Gateway for this interface. Default value is
0.0.0.0
Burned in MAC Address: The Burned in MAC Address used for in-band
connectivity
Locally Administered MAC Address: Can be configured to allow a locally
administered MAC address
MAC Address Type: Specifies which MAC address should be used for
in-band connectivity
Network Configurations Protocol Current: Indicates which network protocol
is being used. Default is none.
Management VLAN Id - Specifies VLAN id
Web Mode: Indicates whether HTTP/Web is enabled.
Java Mode: Indicates whether Java mode is enabled.
Invokes the (Config-if-ma)# prompt, at which you can execute the
address
command.
Configure the management IP address and subnet mask:
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Set the default gateway.
Gateway Address range from 0.0.0.0 to 255.255.255.255
35.
Purpose
The file types are:
startup-config — configuration file
errorlog — Event log
log — System log
traplog — trap log
This starts the upload and also displays the mode of uploading
and the type of upload it is and confirms the upload is taking
place.
If you are using HyperTerminal, specify which file is to be sent
to the switch.
ip
General System Management and