Dell Force10 S2410-01-10GE-24P Command Reference Manual page 135

Example Figure 7-42. Output of the show vlan Command
Force10#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, E - Ethernet interface, ^ - Native VLAN
VlanId
------
* 1
2
4
5
300
Description of the fields in the
Report Fields
Vlan Id: List of configured VLAN IDs
Status: Active or Inactive. A VLAN is active only if the VLAN contains interfaces and those
Q: "T" indicates that the port is tagged; "U" indicates untagged.
Ports:"E" for Ethernet, followed by the port numbers (unit/slot/port) in the VLAN"E ^", followed by
the port numbers in the native VLAN.
The output of the show vlan brief command is shown in the following example:
Example Figure 7-43. Output of the show vlan brief Command
Force10#show vlan brief
VLAN
---------
1
2
3
5
12
13
Fields in the
VLAN: VLAN ID
Name: Assigned VLAN name
MAC Aging: Displayed in seconds
IP Address: IP Address assigned to the VLAN
Status Q Ports
--------- - --------
Active U E
Active U E
T E
U ^Po1
U ^Po2
U ^Po3
Inactive T E
Active U E
T E
Inactive
show vlan
interfaces are operationally up.
Note:
Note, in Figure 7-42, that ports added to VLANs as tagged are also still listed in the
default VLAN 1. If they had been added as untagged, they would be removed from VLAN 1.
Name MAC Aging
---------- --------
abc 1800
egf 1800
sss 1800
1800
1800
1800
show vlan brief
report:
^1/0/1 , 1/0/2 ,^1/0/3 ,^1/0/4 ,^1/0/6 ,^1/0/7
^1/0/8 ,^1/0/9 ,^1/0/10,^1/0/11,^1/0/12,^1/0/13
^1/0/14,^1/0/15,^1/0/16,^1/0/17,^1/0/18,^1/0/19
^1/0/23,^1/0/25,^1/0/26,^1/0/27,^1/0/28,^1/0/29
^1/0/30,^1/0/31,^1/0/32,^1/0/33,^1/0/34,^1/0/35
^1/0/36,^1/0/37,^1/0/38,^1/0/39,^1/0/40,^1/0/41
^1/0/42,^1/0/43,^1/0/44,^1/0/45,^1/0/46,^1/0/47
^1/0/48
^1/0/20,^1/0/21,^1/0/22,^1/0/24
1/0/40, 1/0/42, 1/0/43, 1/0/44
( 1/0/35, 1/0/36, 1/0/37)
( 1/0/10)
( 1/0/15)
1/0/3 , 1/0/44
^1/0/5
^1/0/2 , 1/0/44
report:
IP Address
----------------
unassigned
unassigned
unassigned
unassigned
unassigned
unassigned
VLAN Commands | 135