Dell Force10 S2410-01-10GE-24P Command Reference Manual page 181

Parameters user
password password
Default no password
Mode Global Config
Command
Version 2.5.1.0
History
Usage
The username and password are not case-sensitive.
Information
Six user names can be defined.
users snmpv3 accessmode
This command specifies the SNMP v3 access privileges for the specified login user.
[no] users snmpv3 accessmode username [readonly | readwrite]
Syntax
The username is the login user name for which the specified access mode applies. The default is
readwrite for 'admin' user; readonly for all other users.
The no version of this command sets the SNMP v3 access privileges for the specified login user as
readwrite for the 'admin' user; readonly for all other users. The username is the login user name
for which the specified access mode will apply.
Default admin -- readwrite; other -- readonly
Mode
Global Config
users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login user. The valid
authentication protocols are none, md5 or sha. If md5 or sha are specified, the user login password is
also used as the snmpv3 authentication password and therefore must be at least eight characters in
length. The username is the login user name associated with the authentication protocol.
The no version of this command sets the authentication protocol to be used for the specified login user
to none. The username is the login user name for which the specified authentication protocol will be
used.
Default no authentication
Enter a string to represent the new user's name. The name can be up to eight
characters in length. The name can be comprised of alphanumeric characters,
as well as the dash ('-') and underscore ('_').
keyword
Enter the
cannot be more than eight
Passwords can include special characters. As of SFTOS
2.5.1.3, the following characters are supported: , . { } |.
(period, comma, open bracket, close bracket, bar)
Note: If a user is authorized for authentication, or encryption is enabled, the
password must be at least eight alphanumeric characters in length.
Modified. Added support in password for some special characters.
password
a new password, which
, followed by
characters in length.
alphanumeric
User Account Commands | 181