Expedite Kbps; Expedite Percent - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Sftos command reference
Hide thumbs Also See for Force10 S2410-01-10GE-24P:
Table of Contents

Advertisement

expedite kbps

This command identifies the maximum guaranteed amount of bandwidth to be reserved for the
specified class instance within the named policy using an absolute rate notation. The committed
information rate is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295. The
optional committed burst size is specified in kilobytes (KB) as an integer from 1 to 128, with a default
of 4.
The actual bandwidth allocation does not occur until the policy is attached to an interface in a
particular direction.
expedite kbps <1-4294967295> [1-128]
Syntax
Mode
Policy-classmap Config
Restrictions
The sum of the committed information rate values for all bandwidth and expedite commands defined
within a policy must not exceed the available link bandwidth of the interface to which that policy is
assigned. Violation of this requirement shall prevent successful attachment of a policy to the interface,
or shall cause this command to fail if the policy is already in service on one or more interfaces.
Out
Policy Type
Bandwidth (all forms), Shape Peak
Incompatibilities

expedite percent

This command identifies the maximum guaranteed amount of bandwidth to be reserved for the
specified class instance within the named policy using a relative rate notation. The committed
information rate is specified as a percentage of total link capacity and is an integer from 1 to 100. The
optional committed burst size is specified in kilobytes (KB) as an integer from 1 to 128, with a default
of 4.
expedite percent <1-100> [1-128]
Syntax
Mode
Policy-classmap Config
Restrictions
The sum of the committed information rate values for all bandwidth and expedite commands defined
within a policy must not exceed the available link bandwidth of the interface to which that policy is
assigned. Violation of this requirement shall prevent successful attachment of a policy to the interface,
or shall cause this command to fail if the policy is already in service on one or more interfaces.
Note:
The expedite kbps and percent commands are alternative ways to specify the same
expedite policy attribute.
Note:
The actual bandwidth allocation does not occur until the policy is attached to an
interface in a particular direction.
Note:
The expedite kbps and percent commands are alternative ways to specify the same
expedite policy attribute.
Quality of Service (QoS) Commands | 349

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Force10

Table of Contents