Show Ip Igmp; Show Ip Igmp Groups - Dell Force10 S2410-01-10GE-24P Command Reference Manual

show ip igmp

Syntax
Mode
Example
Report Fields
Related
Commands

show ip igmp groups

Syntax
| IP Multicast Commands
476
This command displays the system-wide IGMP information.
show ip igmp
Privileged Exec and User Exec
Figure 25-137. Example of show ip igmp Command Output
Force10 #show ip igmp
IGMP Admin Mode................................ Enable
IGMP INTERFACE STATUS
Interface Interface Mode
--------- --------------- ---------------
1/0/1 Disable
VLAN 4 Enable
Admin Mode — This field displays the administrative status of IGMP. This is a configured value. If this
field lists "Disable", then the interface-specific fields are empty.
Interface — (Unit/Slot/Port) Valid unit, slot and port number separated by forward slashes.
Interface Mode — This field indicates whether IGMP is enabled or disabled on the interface listed on the
left. This is a configured value.
Protocol State — This field indicates the current state of IGMP on this interface. Possible values are
Operational or Non-Operational. For Operational to be displayed:
The ip igmp command must be configured globally and at the interface.
•
• IP routing must be enabled globally and at the interface level.
• If IP IGMP is enabled on a VLAN interface, then at least one of the member ports of that VLAN
must be active.
ip igmp (global) Sets the administrative mode of IGMP in the router to active.
ip igmp (VLAN) Sets the administrative mode of IGMP for the selected VLAN to active
ip igmp-proxy When used without parameters, this command enables/disables the IGMP Proxy on the
router. When used with the
interface status parameters of the IGMP Proxy router. When used with
unsolicit-report-interval
IGMP Proxy router.
This command displays the registered multicast groups on the interface. If "detail" is specified this
command displays the registered multicast groups on the interface in detail.
show ip igmp groups {unit/slot/port [detail] |
Designate either a port (unit/slot/port) or VLAN number (
Protocol State
Non-Operational
Operational
reset-status
keyword, this command resets the host
, this command sets the unsolicited report interval for the
1-3965 [detail]}
1-3965
), and then, optionally, enter detail.