Dell Force10 S2410-01-10GE-24P Command Reference Manual page 284

Example
Report Fields
| IGMP Snooping Commands
284
Figure 17-104. Output of the show igmpsnooping Command
Force10#show igmpsnooping
Admin Mode...............................Enable
Multicast Control Frame Count............0
Interfaces Enabled for IGMP Snooping.....1/0/10
Vlans enabled for IGMP snooping..........20
Force10-S50 #show igmpsnooping 1/0/1
IGMP Snooping Admin Mode....................... Disable
Fast Leave Mode................................ Disable
Group Membership Interval...................... 260
Max Response Time.............................. 10
Multicast Router Present Expiration Time....... 0
Force10-S50 #show igmpsnooping 3965
Vlan ID........................................ 3965
IGMP Snooping Admin Mode....................... Disabled
Fast Leave Mode................................ Disabled
Group Membership Interval...................... 260
Maximum Response Time.......................... 10
Multicast Router Expiry Time................... 0
When no parameter is specified, the response contains the following fields:
Admin Mode—Enabled or Disabled
Multicast Control Frame Count—The number of multicast control frames that are processed by the CPU
Interfaces Enabled for IGMP Snooping—The list of interfaces on which IGMP Snooping is enabled
Vlans enabled for IGMP snooping—The number of VLANs on which IGMP Snooping is enabled
When the optional argument unit/slot/port is used, the response is as follows:
IGMP Snooping Admin Mode—This indicates whether or not IGMP Snooping is active on the interface.
Fast Leave Mode—Disable or Enabled
Group Membership Interval—This is the amount of time a switch will wait for a report for a particular
group on a particular interface before it sends a query on that interface. This value may be configured
Max Response Time—This displays the amount of time the switch will wait after sending a query on an
interface because it did not receive a report for a particular group on that interface. This value may be
configured.
Multicast Router Present Expiration Time—If a query is not received on an interface within this amount
of time, the interface is removed from the list of interfaces with multicast routers attached. This value
may be configured.
When the optional argument
one more report field is added:
Vlan ID—This echoes the number of the VLAN specified in the parameter.
is used, the response is the same as for unit/slot/port, except that
1-3965