Dell Force10 S2410-01-10GE-24P Command Reference Manual page 281

Related
igmp enable
Commands
(interface)
show igmpsnooping
set igmp maxresponse
Command
Version 2.3
History
Related
igmp maxresponse
Commands
set igmp maxresponse all
This command sets the IGMP Maximum Response time on the system for all the interfaces. The
Maximum Response time is the amount of time in seconds that a switch will wait after sending a query
on an interface because it did not receive a report for a particular group in that interface. This value
must be less than the IGMP Query Interval time value. The range is 1 to 3599 seconds.
The no version of this com
default value.
set igmp maxresponse all <1-3599>
Syntax
no set igmp maxresponse all
Default
10 seconds
Mode Global Config
Related
igmp enable
Commands
(interface)
show igmpsnooping
set igmp mcrtrexpiretime (global)
This command sets the Multicast Router Present Expiration time on the system. This is the amount of
time in seconds that a switch will wait for a query to be received on an interface before the interface is
removed from the list of interfaces with multicast routers attached. The range is 0 to 3600 seconds. A
value of 0 indicates an infinite timeout, i.e. no expiration.
The no version of this command sets the Multicast Router Present Expiration time on the system to 0.
A value of 0 indicates an infinite timeout, i.e. no expiration.
set igmp mcrtrexpiretime 0-3600
Syntax
Enables IGMP Snooping on a selected interface.
Displays IGMP Snooping status information.
igmp maxresponse.
Revised to
Sets the IGMP Maximum Response time on a particular interface.
mand
sets the IGMP Maximum Response time on all interfaces to the
Enables IGMP Snooping on a selected interface.
Displays IGMP Snooping status information.
IGMP Snooping Commands | 281