Dell Force10 S2410-01-10GE-24P Command Reference Manual page 83

snmp-server enable trap violation
This command enables the sending of new violation traps designating when a packet with a disallowed
MAC address is received on a locked port.
[no] snmp-server enable trap violation
Syntax
The no version of this command disables the sending of new violation traps.
Default Disabled
Mode Interface
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
Version 2.5.1
History
Version 2.3
Related
interface range
Commands
interface
snmp-server traps enable
This command enables the Authentication traps.
[no] snmp-server traps enable
Syntax
The no version of this command disables the Authentication traps.
Default enabled
Mode
Global Config
Command
Version 2.3
History
snmptrap
This command adds an SNMP trap receiver name and trap receiver IP address. The maximum name
length is 16 case-sensitive alphanumeric characters.
[no] snmptrap name ipaddr
Syntax
The no version of this command deletes the specified trap receiver from the community.
Default
The default name for the six undefined community names is Delete.
Mode
Global Config
Config; Interface Port Channel Config; Interface Range, which is indicated by the
Added Interface Port Channel Config mode
Added Interface Range mode.
Defines an interface range and accesses the Interface Range mode
Identifies an interface and enters the Interface Config mode.
snmp-server enable traps
Corrected from
System Management Commands | 83