Management Ip Address - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Command Syntax
[no] username user passwd
password
copy
system:running-config
nvram:startup-config
logout

Management IP Address

To view and manage network parameters, you set up the management IP address (see below) so that
you can use the following management methods:
•
•
•
Command Mode
Global Config
Privileged Exec
User Exec and
Privileged Exec
Simple Network Management Protocol (SNMP)
SSH
Telnet
Helpful Hint: After configuring the network parameters, enter write (same effect as
Note:
executing the copy system:running-config nvram:startup-config command), in
Privileged Exec mode, so that the management configuration changes are not lost.
Purpose
This command adds a new user (account) if space permits, along with
the user's password. The user name and password can each be up to
eight alphanumeric characters in length.
no username user
To remove a user, use the
To delete or change a password, remove and reenter the user with the
new password.
Passwords can include special characters. As of SFTOS 2.5.1.3, the
following characters are supported: , . { } |. (period, comma, open
bracket, close bracket, bar)
This will save passwords and all other changes to the device.
If you do not save the configuration by doing this command, all
configurations will be lost when a power cycle is performed on the
switch or when the switch is reset.
In a stacking environment, the running configuration is saved in all units
of the stack.
Logs the user out of the switch.
.
command
Quick Start | 19