Dell Force10 S2410-01-10GE-24P Command Reference Manual page 53

Table 5-8. Fields in Output of show interface ethernet unit/slot/port Command
Field
Physical Status
Speed
Duplex
Link Status
MAC Address
Native Vlan
Total Packets Received (Octets)
Packets Received 1024-1518 Octets
Packets Received > 1522 Octets
(The following fields appear in the output
in this sequence:)
Packets RX and TX 64 Octets
Packets RX and TX 65-127 Octets
Packets RX and TX 128-255 Octets
Packets RX and TX 256-511 Octets
Packets RX and TX 512-1023 Octets
Packets RX and TX 1024-1518 Octets
Packets RX and TX 1519-1522 Octets
Packets RX and TX 1523-2047 Octets
Packets RX and TX 2048-4095 Octets
Packets RX and TX 4096-9216 Octets
Rate Info (interval 300 seconds):
Packets Rx Rate Mbits/sec
Packets Tx Rate Mbits/sec
Packets Rx Rate packets/sec
Packets Tx Rate packets/sec
Packets Rx Line Rate
Packets Tx Line Rate
Packets Received Successfully
Total Packets Received Without Errors
Unicast Packets Received
Description
Whether the port is physically connected or disconnected
The port speed setting
Whether the link is up or down.
MAC address of the port
The total number of octets of data received by the processor
(excluding framing bits but including FCS octets).
The total number of octets of data (including those in bad packets)
received on the network (excluding framing bits but including Frame
Check Sequence (FCS) octets). This object can be used as a
reasonable estimate of Ethernet utilization. If greater precision is
desired, the etherStatsPkts and etherStatsOctets objects should be
sampled before and after a common interval. The result of this
equation is the value Utilization which is the percent utilization of
the ethernet segment on a scale of 0 to 100 percent.
The total number of packets (including bad packets) received that
were greater than 1522 octets in length (excluding framing bits but
including FCS octets).
The total number of packets (including bad packets) received and
sent that were within the range of octets in length (excluding framing
bits but including FCS octets) specified by the field label
Note:
The 1519-1522 frame counter is incremented only for
VLAN-tagged frames. Untagged frames with that size
increment the >1522 counter ("Packets Received > 1522
Octets".
The total number of packets received that were without errors
The number of subnetwork-unicast packets delivered to a
higher-layer protocol
System Management Commands | 53