Show Arp Switch - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Parameters
Default
Mode
Command
History
Related
Commands

show arp switch

Syntax
Mode
Example
Report Fields
Related
Commands
| System Management Commands
42
bootp
Set BootP as the network configuration protocol. This keyword has the switch
periodically send requests to a Bootstrap Protocol (BootP) server until a
response is received.
dhcp
Set DHCP as the network configuration protocol. This keyword has the switch
periodically send requests to a DHCP server until a response is received.
none
This keyword indicates that the switch should be manually configured with IP
information.
none
Interface ManagementEthernet
Version 2.3
Introduced. Replaces the
management route default
interface managementethernet
This command displays connectivity between the switch and other devices. The Address Resolution
Protocol (ARP) cache identifies the MAC addresses of the IP stations communicating with the switch.
show arp switch
Privileged Exec
Figure 5-6. show arp switch Command Example
(Force10) #show arp switch
MAC Address IP Address
------------------- ---------------- ------------
MAC Address—A unicast MAC address for which the switch has forwarding and/or filtering information.
The format is 6 two-digit hexadecimal numbers that are separated by colons, for example
01:23:45:67:89:AB
IP Address—The IP address assigned to each interface
Interface—Ports, displayed as
show arp Displays the Address Resolution Protocol (ARP) cache, all the ARP entries learned through the
routing engine.
network protocol
Sets the IP gateway of the switch.
Invokes the (Config-if-ma)# prompt.
Interface
unit/slot/port
command.