Classofservice Ip-Dscp-Mapping - Dell Force10 S2410-01-10GE-24P Command Reference Manual

classofservice dot1p-mapping
Syntax
Modes
Command
History
Related
Command

classofservice ip-dscp-mapping

Syntax
Modes
Command
History
| Quality of Service (QoS) Commands
328
Table 20-22. Default CoS Queue Prioritization
Queue
0
1
2
3
4
5
6
This command maps an 802.1p priority to an internal traffic class.
classofservice dot1p-mapping
The userpriority value can range from 0-7 and
The no form of this command is not supported.
Global Config; Interface Config; Interface Port Channel Config; Interface Range, which is indicated by
the (conf-if-range- interface
Version 2.3
Version 2.5.1
classofservice dot1pmapping
interface range
show classofservice
dot1p-mapping
This command maps an IP DSCP value to an internal traffic class.
classofservice ip-dscp-mapping
The ipdscp range is from 0-63 and the
available traffic classes depends on the platform. The no form of this command is not supported.
Global Config; Interface Config; Interface Range, which is indicated by the (conf-if-range-
prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3
Fraction (%) of Total Bandwidth
1/28 (3.57%)
2/28 (7.14%)
3/28 (10.71%)
4/28 (14.28%)
5/28 (17.86%)
6/28 (21.43%)
7/28 (25%)
userpriority trafficclass
trafficclass
)# prompt, such as (conf-if-range-vlan 10-20)#.
Interface Range mode added
Interface Port Channel Config mode added
Maps an 802.1p priority to an internal traffic class.
Defines an interface range and accesses the Interface Range mode
Displays the current Dot1p (802.1p) priority mapping to internal traffic
classes for a specific interface
ipdscp trafficclass
trafficclass range is from 0-6, although the actual number of
Interface Range mode added
can range from 0-6.
interface )#