Dell Force10 S2410-01-10GE-24P Command Reference Manual page 478

Example
Report Fields
Related
Commands
| IP Multicast Commands
478
Figure 25-138. Example of show ip igmp interface Command Output
Force10 #show ip igmp interface 1/0/1
Slot/Port...................................... 1/0/1
IGMP Admin Mode................................ Enable
Interface Mode................................. Enable
IGMP Version................................... 3
Query Interval (secs).......................... 125
Query Max Response Time (1/10 of a second)..... 100
Robustness..................................... 2
Startup Query Interval (secs) ................. 31
Startup Query Count............................ 2
Last Member Query Interval (1/10 of a second).. 10
Last Member Query Count........................ 2
Force10#
Unit/Slot/Port—Valid unit, slot and port number separated by forward slashes.
IGMP Admin Mode—This field displays the administrative status of IGMP. This is a
configured value.
Interface Mode—This field indicates whether IGMP is enabled or disabled on the
interface. This is a configured value.
IGMP Version—This field indicates the version of IGMP running on the interface. This
value can be configured to create a router capable of running either IGMP version 1 or 2.
Query Interval—This field indicates the frequency at which IGMP Host-Query packets
are transmitted on this interface. This is a configured value.
Query Max Response Time—This field indicates the maximum query response time
advertised in IGMPv2 queries on this interface. This is a configured value.
Robustness—This field displays the tuning for the expected packet loss on a subnet. If a
subnet is expected to be have a lot of loss, the Robustness variable may be increased for
that interface. This is a configured value.
Startup Query Interval—This value indicates the interval between general queries sent by
a querier on startup. This is a configured value.
Startup Query Count—This value is the number of Queries sent out on startup, separated
by the Startup Query Interval. This is a configured value.
Last Member Query Interval—This value indicates the Maximum Response Time
inserted into Group-Specific Queries sent in response to Leave Group messages. This is a
configured value.
Last Member Query Count—This value is the number of Group-Specific Queries sent
before the router assumes that there are no local members. This is a configured value.
ip igmp (global) Set the administrative mode of IGMP in the router to active.
ip igmp version Set the version of IGMP for an interface or VLAN.
ip igmp (VLAN) Sets the administrative mode of IGMP for the selected VLAN to active
ip igmp-proxy When used without parameters, this command enables/disables the IGMP Proxy on the
router. When used with the
interface status parameters of the IGMP Proxy router. When used with
unsolicit-report-interval
IGMP Proxy router.
reset-status
keyword, this command resets the host
, this command sets the unsolicited report interval for the