Speed All - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Syntax
Default
Mode
speed
Syntax
Parameters
Default
Mode
Command
History
Related
Commands

speed all

Syntax
Parameters
| System Configuration Commands
104
[no] shutdown all
enabled
Global Config
This command sets the speed and duplex setting for the selected interface.
speed {{10 | 100 | 1000} {half-duplex | full-duplex}}
10 half-duplex
Enter
duplex.
10 full-duplex
Enter
100 half-duplex
Enter
duplex.
100 full-duplex
Enter
duplex.
1000 half-duplex
Enter
duplex.
1000 full-duplex
Enter
duplex.
auto-negotiate
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Version 2.3 Added Interface Range mode.
auto-negotiate Enables automatic speed negotiation on a port.
interface range Defines an interface range and accesses the Interface Range mode
interface Identifies an interface and enters the Interface Config mode.
This command sets the speed and duplex setting for all interfaces.
speed all {{10 | 100 | 1000} {half-duplex | full-duplex}}
10 half-duplex
Enter
duplex.
10 full-duplex
Enter
10
to set the speed as 10BASE-T, followed by
10
to set the speed as 10BASE-T, followed by
100
to set the speed as 100BASE-T, followed by
100
to set the speed as 100BASE-T, followed by
1000
to set the speed as 1000BASE-T, followed by
1000
to set the speed as 1000BASE-T, followed by
10
to set the speed as 10BASE-T, followed by
10
to set the speed as 10BASE-T, followed by
half-duplex
for half
full-duplex
for full duplex.
half-duplex
for half
full-duplex
for full
half-duplex
for half
full-duplex
for full
half-duplex
for half
full-duplex
for full duplex.