Radius Commands - Dell Force10 S2410-01-10GE-24P Command Reference Manual

users defaultlogin listname
Syntax
Mode
Global Config
users login
This command assigns the specified authentication login list to the specified user for system login. The
user
If the user is assigned a login list that requires remote authentication, all user access (from all sessions)
will be blocked until authentication is complete.
Note that the login list associated with the 'admin' user cannot be changed to prevent accidental
lockout from the switch.
users login user listname
Syntax
Mode
Global Config

RADIUS Commands

This section contains the following commands for the Remote Authentication Dial-In User Service
(RADIUS), one method for validating administration access to the switch:
•
•
•
•
•
•
•
•
•
•
radius accounting mode
This command is used to enable the RADIUS accounting function.
The no version of this command is used to set the RADIUS accounting function to the default value -
i.e. the RADIUS accounting function is disabled.
radius accounting mode
Syntax
Default
disabled
Mode
Global Config
must be a configured user and the listname must be a configured login list.
radius accounting mode on page 199
radius server host on page 200
radius server key on page 201
radius server msgauth on page 201
radius server primary on page 201
radius server retransmit on page 201
radius server timeout on page 202
show radius on page 202
show radius accounting statistics on page 203
show radius statistics (authentication) on page 204
Security Commands | 199