Dell Force10 S2410-01-10GE-24P Command Reference Manual page 167

Example Figure 8-59. Example Output from show lldp neighbors Commands
(S50) #show lldp neighbors interface 1/0/1
Local Intf
1/0/1
S50# show lldp neighbors interface 1/0/2 detail
Local Interface: 1/0/2
Dead Interval: 14 seconds
Remote Chassis ID: 2
Remote Interface Description: Interface Description
System Name: S50-2
System Description: Best Ethernet Switch
System Capabilities: Router, Switch
Software Version: 2.5.1
IPv4 Address: 10.1.1.1
Speed & Duplex: 1000 Mbps Full
PoE Capable: No
Related lldp mode (global)
Commands
lldp mode (interface)
clear lldp neighbors
show lldp remote-device
Display LLDP configuration for all interfaces.
show lldp remote-device {all | unit/slot/port}.In an SVL system, the [fdbid/all] parameter is not
Syntax
used and will be ignored if entered.
interface unit/slot/port
Parameters
all
Default none
Mode
Privileged Exec
Command
Version 2.5.1
History
Dead Interval Remote Intf
24 2/0/3
Remote Interface: 2/0/4
Tx: 51
Hardware Version:
IPv6 Address: 2000::1
Enable/disable LLDP globally.
Enable/disable LLDP on a selected interface.
Clear LLDP neighbor information.
For a particular interface, enter its ID in
Enter the keyword
Introduced
ChassisID Tx Rx
S50-2 123 23
Rx: 224
Vlan: 10
unit/slot/port
all
for all interfaces.
Link Layer Discovery Protocol (LLDP) Commands | 167
f
ormat.