Show Interfaces Cos-Queue - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Example

show interfaces cos-queue

Syntax
Mode
Field
Descriptions
| Quality of Service (QoS) Commands
334
Figure 20-116. Example of show classofservice trust Command
Force10 #show classofservice trust
Class of Service Trust Mode: Dot1P
Non-IP Traffic Class—The traffic class used for non-IP traffic. This is only displayed when the COS trust
mode is set to trust IP Precedence or IP DSCP (on platforms that support IP DSCP)—either 'trust
ip-dscp' or 'trust ip-precedence'.
Untrusted Traffic Class—The traffic class used for all untrusted traffic. This is only displayed when the
COS trust mode is set to 'untrusted'.
This command displays the class-of-service queue configuration for the specified interface.
show interfaces cos-queue [unit/slot/port]
The parameter is optional and is only valid on platforms that support
unit/slot/port
independent per-port class of service mappings. If specified, the class-of-service queue
configuration of the interface is displayed. If omitted, the most recent global configuration
settings are displayed.
Privileged Exec
Interface—This displays the
output line is replaced with a "Global Configuration" indication.
Interface Shaping Rate—The maximum transmission bandwidth limit for the interface as a whole. It is
independent of any per-queue maximum bandwidth value(s) in effect for the interface.
The following information is repeated for each queue on the interface:
Queue ID—Queue identification number
An interface supports n queues numbered 0 to (n-1). The specific n value is platform dependent.
Min. Bandwidth—The minimum transmission bandwidth guarantee for the queue, expressed as a
percentage. A value of 0 means bandwidth is not guaranteed and the queue operates using best-effort.
Scheduler Type—Indicates whether this queue is scheduled for transmission using a strict priority or a
weighted scheme.
Queue Management Type—The queue depth management technique used for all queues on this
interface.
of the interface. If displaying the global configuration, this
unit/slot/port