Dell Force10 S2410-01-10GE-24P Command Reference Manual page 460

mrinfo
Syntax
Default
Mode
mstat
Syntax
Default
Default
Mode
mtrace
Syntax
Default
| IP Multicast Commands
460
This command is used to query the neighbor information of a multicast-capable router specified by
[ipaddr]. The default value is the IP address of the system at which the command is issued. The mrinfo
command can take up to 2 minutes to complete. Only one mrinfo command may be in process at a
time. The results of this command will be available in the results bufferpool which can be displayed by
using show mrinfo.
mrinfo [
ipaddr ]
none
Privileged Exec
This command is used to find the packet rate and loss information path from a source to a receiver
(unicast router id of the host running mstat). The results of this command will be available in the
results bufferpool which can be displayed by using show mstat. If a debug command is already in
progress, a message is displayed and the new request fails.
mstat
source [ group ] [ receiver
The source is the IP Address of the remote multicast-capable source. The receiver is the IP address of
the receiver. The default value is the IP address of system at which the command is issued. The
is a multicast address of the group to be displayed.
none
The default value of group
Privileged Exec
This command is used to find the multicast path from a source to a receiver (unicast router ID of the
host running mtrace). A trace query is passed hop-by-hop along the reverse path from the receiver to
the source, collecting hop addresses, packet counts, and routing error conditions along the path, and
then the response is returned to the requestor. The results of this command will be available in the
results buffer pool, which can be displayed by using show mtrace.
If a debug command is already in execution, a message is displayed and the new request fails.
,Cs OE [
sourceipaddr destination
The sourceipaddr is the IP Address of the remote multicast-capable source. The
address of the receiver. The default value is the IP address of system at which the command is issued.
The group is the multicast address of the group to be displayed.
none
]
is 224.2.0.1
] [ ]
group
group
receiver is the IP