Show Supported Switchtype - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Preconfigured Model Identifier—This field displays the preconfigured model identifier for this switch. A
Model Identifier is a 32-character field assigned by the device manufacturer to identify the device.
Plugged-in Model Identifier—This field displays the plugged-in model identifier for this switch.
Switch Status—This field displays the switch status. Possible values are OK, Unsupported, Code
Mismatch, Config Mismatch, or Not Present.
Switch Description—This field displays the switch description.
Expected Code Type—This field indicates the expected code type.
Detected Code Version—This field displays the version of code running on this switch. If the switch is
not present and the data is from pre-configuration, then the code version is "None".
Detected Code in Flash—This field displays the version of code that is currently stored in FLASH
memory on the switch. This code will execute after the switch is reset. If the switch is not present and
the data is from pre-configuration, then the code version is "None".
Serial Number—Serial number of the switch.
Up Time—This field displays the system up time.
Related
show hardware
Commands
show sysinfo
show tech-support
show version

show supported switchtype

This command displays information about the switch types supported by the installed version of
SFTOS.
show supported switchtype [switchindex]
Syntax
The switchindex variable is the switch index of the switch model for which you want details. The ID
is listed in the SID field of the show supported switchtype report, as shown in
Mode User Exec; Privileged Exec
Example 1 Figure 12-80. Sample Output from the show supported switchtype Command
Force10-S50 #show supported switchtype
SID
--- -------------------------------- ------------ ---------
1
2
3
Report Fields
When the switchindex variable is not entered, the report fields are as follows:
Switch Index (SID)—This field displays the index into the database of supported switch types. This
index is used when preconfiguring a member to be added to the stack.
Display inventory information for the switch.
Display switch information.
Display a compilation of many "show" commands.
Display details of the software/hardware present on the system
Switch Model ID
S50-01-GE-48T-V
S50-01-GE-48T
S25-01-GE-24P
Mgmt Code
Pref Type
1 0x100b000
1 0x100b000
1 0x100b000
Figure 12-80.
Stacking Commands | 223