Dell Force10 S2410-01-10GE-24P Command Reference Manual page 88
Sftos command reference
Hide thumbs
Also See for Force10 S2410-01-10GE-24P:
- Configuration manual (306 pages) ,
- Manual (42 pages) ,
- Quick start manual (31 pages)
Table of Contents
Advertisement
MAC Database
Commands
cablestatus
Syntax
Mode
auto-negotiate
Syntax
|
System Configuration Commands
88
•
rate-interval on page 98
•
show forwardingdb agetime on page 98
•
show interface loopback on page 99
•
show mac-address-table on page 99
•
show mac-address-table multicast on page 100
•
show mac-address-table stats on page 100
•
show monitor session on page 101
•
show port on page 101
•
show port protocol on page 103
•
shutdown (port) on page 103
•
shutdown all (port) on page 103
•
speed on page 104
•
speed all on page 104
Note:
Broadcast storm control commands are in the ACL chapter, in the section
Storm Control Commands on page
Interface routing commands are in the section
Routing
Commands.
Among the commands in this section are the following four commands that you use to configure and
view information about the MAC address database:
•
bridge aging-time on page 89
•
show forwardingdb agetime on page 98
•
show mac-address-table multicast on page 100
•
show mac-address-table stats on page 100
This command tests the status of the cable attached to an interface.
O rgEnC CWnu
<unit/slot/port>
Privileged EXEC
This command enables automatic speed negotiation on a port.
Note:
Automatic sensing is disabled when automatic negotiation is disabled.
[oe] WCe6oE:eCa CE
The default value is enable.
389.
IP Routing on page 397
Broadcast
in
Chapter 22,
- Quick Links:
- Quick Starting the Switch
Hide quick links:
Advertisement
Table of Contents
