Protocol Static - Dell Force10 S2410-01-10GE-24P Command Reference Manual

protocol static

Syntax
Default
Mode
Usage
Command
History
Related
Commands
rate-interval
service-policy
set garp timer join
set garp timer leave
| LAG/Port Channel Commands
302
interface range
protocol static
This command converts the selected LAG (port channel) from LACP mode to static.
protocol static
disabled
Interface Port Channel Config
LAGs are in LACP mode by default. After you use this command to convert a LAG to static, if you
want to revert the LAG to LACP mode, you would use the protocol lacp command.
Version 2.5.1
interface port-channel
interface range
protocol lacp
This command is available in the Interface Port Channel Config mode.
See rate-interval on page 98
This command is available in the Interface Port Channel Config mode.
service-policy on page 357
See
This command is available in the Interface Port Channel Config mode.
set garp timer join on page 251
See
This command is available in the Interface Port Channel Config mode.
set garp timer leaveall on page 253
See
Defines an interface range and accesses the Interface Range mode
Convert the LAG to static mode.
Introduced, in the new Interface Port Channel Config mode, to replace
port-channel staticcapability.
Accesses the Interface Port Channel Config mode for the selected port
channel.
Defines an interface range and accesses the Interface Range mode
Revert the LAG to LACP mode.
in the System Configuration chapter.
in the System Configuration chapter.
in the GARP Commands chapter.
in the GARP Commands chapter.