ip pimsm crppreference
Syntax
Default
Mode
Command
History
Related
Commands
ip pimsm datathreshrate
Syntax
Default
Mode
ip pimsm message-interval
|
PIM Commands
490
This command is used to configure the Candidate Rendezvous Point (CRP) for a particular PIM-SM
interface. The valid values are from (1 to 255), and the value of -1 is used to indicate that the local
interface is not a Candidate RP interface.
The active router interface, with the highest IP Address and crppreference greater than -1, is chosen as
the CRP for the router. The default value is 0.
In the CRP advertisements sent to the bootstrap router (BSR), the router interface advertises itself as
the CRP for the group range 224.0.0.0 mask 240.0.0.0.
ip pimsm crppreference -1-255
no ip pimsm crppreference
The no version of this command is used to reset the Candidate Rendezvous Point (CRP) for a
particular PIM-SM interface to the default value.
0
Interface Config or Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3
interface range
Defines an interface range and accesses the Interface Range mode
interface vlan
Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
This command is used to configure the data Threshold rate for the PIM-SM router. The rate is specified
in Kilobytes per second. The possible values are 0 to 2000.
ip pimsm datathreshrate 0-2000
no ip pimsm datathreshrate
The no version of this command is used to reset the data Threshold rate for the PIM-SM router to the
defaule value.
50
Global Config
This command is used to configure the global join/prune interval for PIM-SM router.
Added Interface Range and Interface VLAN modes.