Dell Force10 S2410-01-10GE-24P Command Reference Manual page 56

| System Management Commands
56
Table 5-8. Fields in Output of show interface ethernet unit/slot/port Command
Field
Broadcast Packets Transmitted
Transmit Errors
Total Transmit Errors
FCS Errors
Tx Oversized
Underrun Errors
Total Transmit Packets Discarded
Single Collision Frames
Multiple Collision Frames
Excessive Collision Frames
Port Membership Discards
Protocol Statistics
BPDU's received
BPDU's Transmitted
802.3x Pause Frames Transmitted
GVRP PDUs received
GVRP PDUs Transmitted
GVRP Failed Registrations
GMRP PDUs received
GMRP PDUs Transmitted
GMRP Failed Registrations
STP BPDUs Transmitted
STP BPDUs Received
Description
The total number of packets that higher-level protocols requested be
transmitted to the Broadcast address, including those that were
discarded or not sent
The sum of Single, Multiple, and Excessive Collisions
The total number of packets transmitted that had a length (excluding
framing bits, but including FCS octets) of between 64 and 1518
octets, inclusive, but had a bad Frame Check Sequence (FCS) with
an integral number of octets
The total number of frames that exceeded the max permitted frame
size. This counter has a max increment rate of 815 counts per sec. at
10 Mb/s.
The total number of frames discarded because the transmit FIFO
buffer became empty during frame transmission
The sum of single collision frames discarded, multiple collision
frames discarded, and excessive frames discarded
A count of the number of successfully transmitted frames on a
particular interface for which transmission is inhibited by exactly
one collision
A count of the number of successfully transmitted frames on a
particular interface for which transmission is inhibited by more than
one collision
A count of frames for which transmission on a particular interface
fails due to excessive collisions
The number of frames discarded on egress for this port due to egress
filtering being enabled
The count of BPDUs (Bridge Protocol Data Units) received in the
spanning tree layer
The count of BPDUs (Bridge Protocol Data Units) transmitted from
the spanning tree layer
A count of MAC Control frames received on this interface with an
opcode indicating the PAUSE operation. This counter does not
increment when the interface is operating in half-duplex mode.
The count of GVRP PDUs received in the GARP layer
The count of GVRP PDUs transmitted from the GARP layer
The number of times attempted GVRP registrations could not be
completed
The count of GMRP PDU's received in the GARP layer
The count of GMRP PDU's transmitted from the GARP layer
The number of times attempted GMRP registrations could not be
completed
Spanning Tree Protocol Bridge Protocol Data Units sent
Spanning Tree Protocol Bridge Protocol Data Units received