Dell Force10 S2410-01-10GE-24P Command Reference Manual page 225

switch priority
This command configures the ability of a switch to become the management unit in a stack.
switch unit priority value
Syntax
The unit is the switch identifier.
The value is the preference parameter that allows the user to specify the priority of one backup switch
over another. The priority range is 0 to 15. The switch with the highest priority value will be chosen to
become the management unit if the active management unit fails. The switch priority defaults to the
hardware management preference value 1. Switches that do not have the hardware capability to
become the management unit are not eligible for management. If priority is 0, then the unit is not
considered as a potential candidate to become the management unit when the current management unit
fails.
Default enable
Mode
Global Config
switch renumber
This command changes the switch ID for a switch in the stack.
switch oldunit renumber newunit
Syntax
The
The
Mode
Global Config
Related
member
Commands
movemanagement
oldunit is the current switch identifier on the switch whose identifier is to be changed.
newunit is the updated value of the switch identifier.
Caution:
When you renumber the management unit, the current configuration is lost and
default configuration is loaded.
Pre-configures a switch as a member of the stack
Moves the management unit functionality from one switch to another
Stacking Commands | 225