Spanning-Tree Port Mode Enable; Spanning-Tree Port Mode Enable All - Dell Force10 S2410-01-10GE-24P Command Reference Manual

spanning-tree port mode enable

Syntax
Default
Mode
Command
History
Related
Commands

spanning-tree port mode enable all

Syntax
Default
Mode
Command
History
Related
Commands
| Spanning Tree (STP) Commands
326
This command sets the Administrative Switch Port State for this port to enabled.
The no version of this command sets the Administrative Switch Port State for this port to disabled.
[no] spanning-tree port mode enable
disabled
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Version 2.3
Modified: Added
interface Identifies an interface and enters the Interface Config mode.
interface range Defines an interface range and accesses the Interface Range mode
spanning-tree (LAG) Sets the spanning-tree operational mode on the selected LAG.
spanning-tree Enable spanning tree on the switch.
spanning-tree port mode Enable spanning tree on all ports.
enable all
This command sets the Administrative Switch Port State for all ports to enabled.
[no] spanning-tree port mode enable all
The no version of this command sets the Administrative Switch Port State for all ports to disabled.
disabled
Global Config
Version 2.3
Modified: Added
spanning-tree
spanning-tree port mode enable
enable
keyword. Added Interface Range and Interface VLAN modes.
enable
keyword.
Enable spanning tree on the switch.
Enable spanning tree on the selected port.