Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 423

IP Commands
ip interface
Configures an IP interface to enable IP routing on a VLAN or allow remote access. Without an IP inter-
face, traffic is bridged within the VLAN or across connections to the same VLAN on other switches.
ip interface {name | emp} [{address | vip-address} ip_address] [mask subnet_mask] [admin-state
[enable | disable]] [vlan vlan_id] [forward | no forward] [local-proxy-arp | no local-proxy-arp] [e2 |
snap] [primary | no primary]
no ip interface name
Syntax Definitions
name
emp
address ip_address
vip-address ip_address
subnet_mask
enable
disable
vlan_id
forward
no forward
local-proxy-arp
no local-proxy-arp
e2
snap
primary
no primary
OmniSwitch CLI Reference Guide
Text string of interface name. Use quotes around string if description
contains multiple words with spaces between them (e.g. "Alcatel-Lucent
Marketing"). Note that this value is case sensitive.
Modifies the shared EMP port IP address.
An IP host address (e.g. 10.0.0.1, 171.15.0.20) to specify the IP router
network.
An IP host address for a Virtual IP (VIP) VLAN. This type of IP
address is used only in a Multi-Chassis Link Aggregation (MC-LAG)
configuration.
A valid IP address mask (e.g., 255.0.0.0, 255.255.0.0) to identify the IP
subnet for the interface.
Enables the administrative status for the IP interface.
Disables the administrative status for the IP interface.
An existing VLAN ID number (1–4094). Specify a multi-chassis VLAN
ID if the IP interface is for a VIP VLAN.
Enables forwarding of IP frames to other subnets.
Disables forwarding of IP frames. The router interface still receives
frames from other hosts on the same subnet.
Enables Local Proxy ARP on the specified interface.
Disables Local Proxy ARP on the specified interface.
Enter e2 or ethernet2 to specify Ethernet-II encapsulation.
SNAP encapsulation.
Designates the specified IP interface as the primary interface for the
VLAN.
Removes the configured primary IP interface designation for the
VLAN. The first interface bound to the VLAN becomes the primary by
default.
March 2011
ip interface
page 10-5