System Default Zone Default-Zone Permit - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

system default zone default-zone permit

To configure default values for a zone, use the system default zone default-zone permit command in
configuration mode. To revert to the defaults, use the no form of the command.
Syntax Description This command has no arguments or keywords.
Defaults
No default values for zones.
Command Modes
Configuration mode.
Command History Release
3.0(1)
Usage Guidelines This command defines the default values for the default zone for all VSANs. The default values are used
when you initially create a VSAN and it becomes active. If you do not want to use the default values,
use the zone default-zone permit vsan command to define the operational values for the default zone.
The system default zone default-zone permit command should only be used in conjunction with
VSANs that have not yet been created; it has no effect on existing VSANs.
Because VSAN 1 is the default VSAN and is always present, this command has no effect on it.
Note
Examples The following example sets the default zone to use the default values.
switch# config terminal
switch(config)# system default zone default-zone permit
The following example restores the default setting.
switch(config)# no system default zone default-zone permit
Related Commands Command
zone default-zone
permit vsan
show system default
zone
OL-18089-01, Cisco MDS NX-OS Release 4.x
system default zone default-zone permit
no system default zone default-zone permit
Modification
This command was introduced.
Description
Defines whether a default zone (nodes not assigned a created zone) permits
or denies access to all in the default zone.
Displays default values for the default zone.
system default zone default-zone permit
Cisco MDS 9000 Family Command Reference
21-103