Port Leds And Modes - Cisco Catalyst 9300X Hardware Installation Manual

Port LEDs and Modes

Color
Amber
Blinking amber
Port LEDs and Modes
Each Ethernet port, 1-Gigabit Ethernet module slot, and 10-Gigabit Ethernet module slot has a port LED.
These port LEDs, as a group or individually, display information about the switch and about the individual
ports. The port mode determines the type of information shown by the port LEDs.
To select or change a mode, press the Mode button until the desired mode is highlighted. When you change
port modes, the meanings of the port LED colors also change.
When you press the Mode button on any switch in the switch stack, all the stack switches change to show the
same selected mode. For example, if you press the Mode button on the active switch to show the SPEED
LED, all the other switches in the stack also show the SPEED LED.
Table 12: Port Mode LEDs
Mode LED
STAT
SPEED
DUPLX
ACTV
STACK
PoE
1
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
18
Description
There is a fault: load shedding is occurring, a StackPower cable is defective, or an
administrative action is required. See the switch software configuration guide for
information about configuring StackPower.
The StackPower budget is not sufficient to meet current power demands.
Port Mode
Port status
Port speed
Port duplex mode
Active
Stack member status
StackWise port status
1
The PoE+ port status.
Only switches with PoE+ ports.
Description
The port status. This is the default mode.
The port operating speed: 10, 100, or 1000 Mb/s.
The port duplex mode: full duplex or half duplex.
The active switch status.
Stack member status.
The StackWise port status. See
The PoE+ port status.
Product Overview
STACK LED, on page 16.